Black quartz countertop slabs refer to cabinet countertops made of quartz stone. Quartz countertops are made from crushed glass and quartz sand. The advantage of quartz stone is that it is wear-resistant and not afraid of scratches. Quartz stone is a new type of stone that is artificially synthesized by more than 90% of quartz crystals plus resin and other trace elements. When installing quartz stone countertops, everyone will take the countertop installation work very important. In fact, the connection work after installation is also very important. Next, let's take a look at the installation work of black quartz countertop slabs water blocking connections.

The preparation work is to confirm the design drawings or personal requirements for the rear water barrier, and check the size of the water barrier. For the water retaining strip, there are two kinds of back retaining water paste, which are also different in the processing and installation method according to the different craftsmanship of the master. But it achieves the expected result!

Method 1: Use a T-shaped knife to make a 3×25mm step at the water-blocking bonding position at the back of the countertop block, stick the gong line on the step, use the gong knife to create an arc and stick the water-blocking strip. This method is suitable for on large particle plates.

Method 2: The connection method is to first connect and glue one of the standard water-blocking pieces in parallel with the black quartz countertop slabs. Before bonding, check the uniformity of the butting surface and clean the connecting surface, and then use a gong machine to glue it. Draw out the drawing on the good gong line. It is recommended to use a 1/2×7/8 round bottom knife for the gong knife used. The distance between the round bottom knife and the table top and the distance between the top of the round bottom knife arc and the table top are printed in A4. The paper can be easily twitched. After the arc gong is finished, clean the upper plane part of the arc of the gong line. The general width of the plane part is the thickness or width of the plate itself.